Do you use Simulink® and Stateflow® from MathWorks? These tools are powerful and often a central part in the engineering tool chain. Models and block libraries created with them carry valuable engineering knowledge of your development team and organization. The more important the models are the more people use them as a source of information for their everyday work. Reflecting the development process, there are many usage scenarios that need access to the models but are not about editing and simulating models. This is typical in testing scenarios but can also be found within implementation tasks. For these scenarios, viewer for models and libraries would be sufficient. So what are the pros and cons of using Simulink and Stateflow viewers?
Simulink® and Stateflow® provide a functionality that goes far beyond read-only use cases. But if you just want to read and analyse models, features for editing and simulation can be considered an unnecessary weight that has to be carried around.
A model browser can cut off this extra weight and provide a focussed user interface. It can provide a much simpler and more direct access that better supports users browsing models and finding information. This should include:
Additional use cases are comparing and merging different model versions or tracing back to requirements.
Additionally, a lean application tends to be faster. This is mainly relevant for large models. It makes a difference if opening a (very) large model takes a few seconds before you can start working with it or if you have to wait for over two minutes.
This is annoying especially if you just want to take a quick look into a model. A viewer can provide access without any need for a Simulink® installation and licence.
As viewers are typically lightweight tools with a restricted yet optimized set of features they are cheaper and provide a way to cut license costs. You can find more information regarding licence costs in our blog post 'How to reduce simulink license costs?'
So using a Simulink viewer or Stateflow viewer is a pragmatic and cost efficient alternative to read and analyse models for use cases that do not require model editing and simulation features.
Simulink® and Stateflow® are registered trademarks of The MathWorks, Inc.